MFK 700 KA EQ-Plus

With a bigger base support for those overhanging edges: perfect for flush trimming or rounding off those pesky edges. The ball bearing brake stops any damage to delicate edges.

The routing depth can be fine-tuned to a tenth of a millimetre. The user-friendly clamp handle stops the router table from shifting while you're working.

The S8 HW MFK facing cutter can also be used to route edges flush, even for angled edges. The chip deflector is shaped so that it acts as a guiding aid, irrespective of the edge angle.

The router can be changed quickly and easily thanks to the spindle stop.

An integrated extraction channel in the wide support table whisks the shavings away upwards. Statically charged, sticky plastic shavings are sucked up effectively.

With the MMC electronics, you can quickly tweak the speed to match the material you're working with, and it stays steady when under load. Plus, the motor's temperature monitoring helps ensure it lasts a good long while.

Thanks to the plug-it system, the device can be changed quickly – directly via the cable and not via the socket or extractor: One cable for all devices. And even if the cable breaks, it can be replaced quickly without any problems.