Hole drilling set LR 32-SYS
- guide plate
- centring mandrel
- hinge location cutter HM Ø 35 mm
- dowel drill HW Ø 5 mm (V-shaped tip)
- dowel drill HM Ø 5 mm (with centring bit and pre-cutter)
- 2 parallel side fences with adjustable stop
- clamp FSZ 120
- 2x Longitudinal stop
- screwdriver, WAF 5
- in SYSTAINER SYS 1 T-LOC
Holes in series.
Hole series are always drilled with a spacing of 32 mm and a hole diameter of 5 mm or 3 mm. The hole series drilling system is a complete set for fast and simple production of series of holes for shelf supports, rear wall supports and fittings with the OF 1010 or OF 1400 router. Everything in a single SYSTAINER.
- for use with hole line guide rails
- Complete range for preparing holes series with 32 mm spacing
- Including dowel drill dia. 5 mm and clamps